Nagios Support Forum

Hi,

Can you show how this can be achieve go step-by-step?


Thanks,
Soo How

This is about monitoring Cisco catalyst access switch C9200L. Knowing that we can make use of the Network switch configure to auto discover all the switch ports, etherchannel, stack ports, etc. However, we don't see the CPU usage, Memory usage, Fans condition, Volts, more towards the core operations...

Hi,

I used nmap to detect the port 161 on the Nagios server. I tried "nmap -p 161 10.224.74.131" and the result was,

PORT STATE SERVICE
161/tcp filtered snmp

Soo How,

Dear all, Please see the answers, 1. Linux Distribution and version? 32 or 64bit? RHEL9 on AWS EC2 Instance 2. VMware Image or Manual Install of XI? Manual install 3. Are there special configurations on your system, ie; is Gnome installed? Are you using a proxy? Are you using SSL? None *Note: this i...

This is an attempt to configure my Cisco access switch with IP address - 10.224.74.131, using the network switch wizard in Configure. We have checked that the v2c community is correct. However, we can't get the switch under monitoring with error messages stating that we have to run the command below...