Nagios Support Forum

Good morning, I was wondering if there is an official guide for Nagios XI to see how to upgrade a switch in Nagios XI correctly. For example we have upgraded a switch in an IDF from a Cisco Catalyst 3750 to a 6500. The IP remained the same, but obviously the port for the uplink changed, so bandwidth...

I have been monitoring ports on that device. That's how I went through it: At first there was the initial device configuration with a gigabit port and VLAN being monitored for status and bandwidth. Now I wanted to add more devices to the monitoring, so I went through the wizard for the device, howev...

Yes, I'm able to see graphs for other devices through Host Graphs and Graphs Explorer.

The rrd aren't being generated at all. I added the ports through the XI Switch/Router wizard, so the service wasn't renamed at all.

Hello, I am experiencing trouble with my Nagios XI trial copy. A port (in this case an AP on a Cisco switch) is added through the Switch/Router wizard, and it shows up normally. However, when it starts checking it gives me the following message: "/var/lib/mrtg/<switchname>_299.rrd does not exis...

The hardware it's running on is a ESXi host on a Dell PowerEdge 2850, running ESXi 4.1.0, 4 CPUs x 2.793 GHz. The VM is "VM Version 7", 3 cores, 2048MB RAM. Mod Gearman sounds interesting, but for now I'd rather try to run on one VM. There are about 913 active checks going on in the next 5...

I am currently running the evaluation version of Nagios XI, and we are experiencing a lot of alerts about local host being critical (CRITICAL - load average: 18.30 21.19 22.88). I used the pre-installed VMware image and I attached the installation profile. I already ran through this guide (http://as...