Nagios Support Forum

Installed 0.3.9. No joy
Same results: Warning: No data was received from host.
So Nagios 'knows' the server exists, it just isn't getting the data.
????
Might have to give up and just install a stand alone Nagios server.

Well, I am pretty sure that that is not the problem as it is a Windows server 2008 guest that has 'shares' to another Windows server 2008 guest on the same host. But here is the relevant info .... <interface type='direct'> <mac address='52:54:00:05:09:4b'/> <source dev='br0' mode='bridge'/> <model t...

# If you want to fill this file with all avalible options run the following command: # nscp settings --generate --add-defaults --load-all # If you want to activate a module and bring in all its options use: # nscp settings --activate-module <MODULE NAME> --add-defaults # For details run: nscp settin...

br0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.0.20 netmask 255.255.255.0 broadcast 192.168.0.255 ether 54:9f:35:02:d0:ee txqueuelen 1000 (Ethernet) RX packets 212993554 bytes 280160138733 (260.9 GiB) RX errors 0 dropped 1639358 overruns 0 frame 0 TX packets 123356812 bytes 28...

Sorry, didn't see the 'page 2' and I don't seem to be getting emails when responses are posted. Nagios Server IP - 192.168.0.25 Windows Server IP - 192.168.0.21 allowed hosts = 192.168.0.25 I have restarted the NSClient service to no avail. As I stated in a previous post I can ping each computer fro...

Here is the result from the nsclient log file:

2015-01-16 12:52:37: e:D:\source\nscp\trunk\include\socket/connection.hpp:134: Failed to read data: The I/O operation has been aborted because of either a thread exit or an application request

rather cryptic (at least for me).

Not running NRPE, but get the same message when I check the 'check_nt': No data was received from host! could not fetch information from server Strange thing is that nagios reports that the 'host is up' so it is able to recognize the existence of the windows server, just can't pass data. Really stra...

Yes.

Not only did I put in a space, but I realized I tried this from the Host not the guest that is running Nagios :-( Starting Nmap 6.47 ( http://nmap.org ) at 2015-01-16 09:12 MST Nmap scan report for shelter-03.hslc (192.168.0.21) Host is up (0.00058s latency). PORT STATE SERVICE 5666/tcp open nrpe 12...

Sorry, didn't get the email that there was a reply. Starting Nmap 6.40 ( http://nmap.org ) at 2015-01-15 14:55 MST setup_target: failed to determine route to 12489 (0.0.48.201) Nmap scan report for 192.168.254.117 Host is up (0.00022s latency). PORT STATE SERVICE 5666/tcp open nrpe MAC Address: 52:5...