Nagios Support Forum

Thanks guys, the longer timeout does help through the issue. Please close the ticket and I'm very appreciated for your help. Great product for customisation when needed

Thanks you I will set the timeout for 40 and see how it goes,

Yes, I can set the timeout to longer, dos this really counter the latency over the WAN?

Hi Box293,

Please see attached, as mention previously the services is flapping stage. is there way to tune for checking services multiple time before it confirm the status (by-pass the flapping)

Hi Guys, I'm aware there is a latency issue for using this method to monitor a remote host over the WAN link. I have setup the host monitor over the WAN however I am constantly getting services are flapping. I have also enable passive check however I'm not familiar with all other setting and hope so...

Hi hsmith,

Please mark as resolved,

I haven't does a clean installation of nrpe, I have remove all nrpe and reinstall fresh nrpe and it is working.

Thanks,

Hi Lmiltchev,

Please mark as resovled

Thanks,

Hi lmiltchev,

Please mark as resolved, as I tried to implement nagiosgraph third party into Nagios Xi and generate all sort of graph issue.

Removing nagiosgraph and using the built-in nagios xi are working

Thanks again

Hi, Been awhile and I should provide the resolution of my own issue and it is all working now. Since getting the old nrpe (none-SSL) box to talk with the newer Nagios Xi system, By default Nagios Xi used SSL. All I have to do is compile NRPE and Nagios-Plugin on the old Linux box with disable SSL. P...

ip addr 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen...