Nagios Support Forum

Thanks dwhitfield.

i going to try setting this.

do you know if after set this, and i restart nagios services, nagios will send me the alert again because he thinks that it should send the alert?

Dear team,

When a host is down, i can get the email alert perfectly.
What i need is that nagios send only one mail and not much of them.

I have set the time interval but i´m not looking for this. I just want only one email when a host goes down

thanks thanks

Dear mates, I wish to check my xenserver status and hosts running into. I saw a lot of pluging for xenserver but cant found any manual or intructions. I understood you have to installa xenAPI on xenserver but i need more intructions. my goals on this are: - Check vms status - Check storage xenserver...

So, if i have understood, it´s means that NNA doesn´t handdle cisco catalyst series and cisco small bussiness?

I will not purchase this nagios´s complement.

Thank you for the information

Thanks for your reply bwallace. I´ve read your link. But, what about cisco catalyst 2960 series, i have a lot of them. I know that they are possible to monitoring but i can´t find the right configuration to enable de netflow data to send nagios network analyzer Can you Help Me? thanks you very much

Hi there,

Need information to get dataflow from switches model SGE 2000.

The manuals i´ve found talks about CISCO ASA and Router 2600 series..


Thanks a lot

Hi tgriep
thank you for your reply.

I ´ve solved the problem adding a -v (verbose) on my commnad ( check_port -h %arg...etc etc -v)
after thar pnp4nagios y showing me the correct graph


hope help more people

remind that no all command support -v

best regards!

Hi there, im noob in pnp4nagios I´ve installed and i can see the graph correc with "ping,cpu load,memoria,disk,etc" But i use to use a command that check ports in my wan networks ( tipical check_port) My problem is when is add "srv-pnp" or " host-pnp" to a host that im ...