Support forum for Nagios Core, Nagios Plugins, NCPA, NRPE, NSCA, NDOUtils and more. Engage with the community of users including those using the open source solutions.
Name/OID: prtMarkerSuppliesMaxCapacity.1.5; Value (Integer): -2 (this is iso.3.6.1.2.1.43.11.1.1.9.1.5 from above trough mibbrowser)
The current level if this supply is a container;the
remaining space if this supply is a receptacle. If this
supply container/receptacle can reliably sense this
value, the value is sensed by the printer and is
read-only;otherwise, the value may be written (by a
Remote Contol Panel or a Management Application). The
value (-1) means other and specifically indicates that
the sub-unit places no restrictions on this parameter.
The value (-2) means unknown. A value of (-3) means that the
printer knows that there is some supply/remaining space,
respectively.
You may need to contact the manufacturer about that OID returning -2.
Does the printer show the status of the waste level on the printer itself?
Is there a firmware upgrade for the copier that you can install?
Be sure to check out our Knowledgebase for helpful articles and solutions!
It only shows OK, trough the website of the printer. i am not sure but it shows an empty box followed by OK on the printer itself.
But it is a bit vague, at some point it shows "the waste toner is almost full, prepare waste toner". "followed by the waste toner is full, replacement is needed" that is everything i know about the waste toner, and the -2.
I dont know yet, i need the password to enter the admin settings and i dont know this. i have to ask the administrator. (he will probaly say no if i want to upgrade the firmware if it is outdated)