Cannot run check_nrpe from Linux to Windows server with SSL
Posted: Fri Sep 30, 2016 3:49 am
I'm following this guide: https://www.medin.name/blog/2012/12/02/ ... ntication/
I'm running nsclient++ on windows server, and installed our Active Directory CA certificate + certificates signed for the windows server in the security/ directory.
If I run nscp test on the windows server itself with following command, it's successful.
However, if I run it from my nagis host, I always get on Windows server side "sslv3 alert handshake failure: 1040".
From my command line on the linux host:
The client.pem is signed by the same Active Directory CA
I'm running nsclient++ on windows server, and installed our Active Directory CA certificate + certificates signed for the windows server in the security/ directory.
If I run nscp test on the windows server itself with following command, it's successful.
Code: Select all
nscp nrpe --host 127.0.0.1 --ca security\ca.pem --verify peer-cert --allowed-ciphers ALL:!ADH:!LOW:!EXP:!MD5:@STRENGTH --certificate security\server.pem --certificate-key security\server_key.pem
I (0.5.0.62 2016-09-14) seem to be doing fine...
From my command line on the linux host:
Code: Select all
./check_nrpe -H x.x.x.x -A ../etc/ssl/ca.pem -C ../etc/ssl/client.pem -K ../etc/ssl/client_key.pem
CHECK_NRPE: Error - Could not complete SSL handshake with x.x.x.x: 1