check_nrpe problems: Unable to read output and seteuid(0)

This board serves as an open discussion and support collaboration point for Nagios XI. NOTE: Nagios XI customers should use the Customer Support forum to obtain expedited support.

Re: check_nrpe problems: Unable to read output and seteuid(0

Postby markgreene » Tue Jun 18, 2019 3:15 pm

And I fixed it. Under "configure service", "monitoring" tab, I changed the command string to this:

check_nrpe!check_disk_all!5!10

removed the "-n" from /etc/sysconfig/nrpe on the remote host (added only because it was failing on SSL out of the gate), and restarted nrpe and forced the command.

So the short answer is the webUI NRPE wizard can't correctly construct complex commands, and I will verify the command strings under the "configure services" tab in the future.

mark
markgreene
 
Posts: 10
Joined: Mon Jun 17, 2019 9:44 am

Re: check_nrpe problems: Unable to read output and seteuid(0

Postby scottwilkerson » Wed Jun 19, 2019 8:10 am

markgreene wrote:And I fixed it.

Glad to hear it is resolved!

Locking thread
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
User avatar
scottwilkerson
DevOps Engineer
 
Posts: 15047
Joined: Tue Nov 15, 2011 3:11 pm
Location: Nagios Enterprises

Previous

Return to Nagios XI

Who is online

Users browsing this forum: surmeena, thfadmin and 15 guests