problems with drives bigger than 2TB

This board serves as an open discussion and support collaboration point for Nagios XI. NOTE: Nagios XI customers should use the Customer Support forum to obtain expedited support.

problems with drives bigger than 2TB

Postby jodonnell » Tue Aug 20, 2019 10:15 am

I just downloaded the Nagiosxi demo. I am trying to monitor a Linux disk using snmp. I am monitoring a few drive that report correctly. however I have one disk that is 10TB. the monitor reports that I am using 5TB out of 2TB, or %253.

check_xi_service_snmp_linux_storage! --login=***** --passwd=***** --privpass=***** --protocols=md5,des -m "^/sasdata$" -w 80 -c 95 -f

/sasdata: 253%used(5308729MB/2096396MB) (>95%) : CRITICAL
jodonnell
 
Posts: 1
Joined: Tue Aug 20, 2019 10:03 am

Re: problems with drives bigger than 2TB

Postby mbellerue » Tue Aug 20, 2019 10:56 am

This is a known issue with Net-SNMP. You can add the following to your /etc/snmp/snmpd.conf file, which should solve the issue.

Code: Select all
realStorageUnits 0
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.

Be sure to check out our Knowledgebase for helpful articles and solutions!
User avatar
mbellerue
 
Posts: 414
Joined: Fri Jul 12, 2019 11:10 am


Return to Nagios XI

Who is online

Users browsing this forum: No registered users and 5 guests