Issue adding Router - SNMP output
Posted: Wed Aug 28, 2019 4:28 pm
Here is the output of my SNMP of my Router. I keep getting an error that ...
Bandwidth and Port Status
No ports were detected on the switch. Possible reasons for this include:
The switch is currently down
The switch does not exist at the address you specified
SNMP support on the switch is disabled
None of these are true. I have setup the SNMP on the device just like others on the same subnet.
# Created by
# /usr/bin/cfgmaker --show-op-down --noreversedns --zero-speed 10000000 MTR@172.16.100.1:161::::2
### Global Config Options
# for UNIX
# WorkDir: /home/http/mrtg
# or for NT
# WorkDir: c:\mrtgdata
### Global Defaults
# to get bits instead of bytes and graphs growing to the right
# Options[_]: growright, bits
EnableIPv6: no
######################################################################
# System:
# Description:
# Contact:
# Location:
######################################################################
Bandwidth and Port Status
No ports were detected on the switch. Possible reasons for this include:
The switch is currently down
The switch does not exist at the address you specified
SNMP support on the switch is disabled
None of these are true. I have setup the SNMP on the device just like others on the same subnet.
# Created by
# /usr/bin/cfgmaker --show-op-down --noreversedns --zero-speed 10000000 MTR@172.16.100.1:161::::2
### Global Config Options
# for UNIX
# WorkDir: /home/http/mrtg
# or for NT
# WorkDir: c:\mrtgdata
### Global Defaults
# to get bits instead of bytes and graphs growing to the right
# Options[_]: growright, bits
EnableIPv6: no
######################################################################
# System:
# Description:
# Contact:
# Location:
######################################################################