Hi All,
Few of the services in Nagios XI , when run from "Run Check Command" and also from terminal it is giving expected output.
However the service status in GUI dashboard is showing critical\unknown.
Please suggest.
Regards,
Priyanka Bachu
Nagios XI--Run Check Command
Re: Nagios XI--Run Check Command
Does it give you a message under Status Information?
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
Be sure to check out our Knowledgebase for helpful articles and solutions!
Be sure to check out our Knowledgebase for helpful articles and solutions!
Re: Nagios XI--Run Check Command
Hi ,
Thanks for your reply.
No I am getting critical message in status information.
"SOAP UNKNOWN: failed to access SOAP API".
But below is the output of "Run Check Command"
SOAP OK: 0.010 | 'messages'=0.010;300;600;;
Please suggest
Regards,
Priyanka Bachu
Thanks for your reply.
No I am getting critical message in status information.
"SOAP UNKNOWN: failed to access SOAP API".
But below is the output of "Run Check Command"
SOAP OK: 0.010 | 'messages'=0.010;300;600;;
Please suggest
Regards,
Priyanka Bachu
Re: Nagios XI--Run Check Command
Is this a plugin that was downloaded from Exchange? This really sounds like a plugin that is either out of date, or has requirements that haven't been met.
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
Be sure to check out our Knowledgebase for helpful articles and solutions!
Be sure to check out our Knowledgebase for helpful articles and solutions!