MRTG and Nagios XI

This board serves as an open discussion and support collaboration point for Nagios XI. NOTE: Nagios XI customers should use the Customer Support forum to obtain expedited support.

MRTG and Nagios XI

Postby cdcrawford » Tue Oct 29, 2019 12:24 pm

Good afternoon,

I have used the Nagios XI Config Wizard to add a switch/router to monitor bandwidth.

I've looked at the MRTG configuration after it was done, which appears to only be monitoring bandwidth, which is fine. I'd like to also montior ifErrors, ifDiscards. Both in and out. On one graph.

Is this something that I can do?

This is the output from my mrtg config for the port.
Code: Select all
Target[IP-addr_192]: 192:public@IP-addr:::::3
SnmpOptions[IP-addr_192]: privpassword=>'privPass',authpassword=>'authPass',authprotocol=>'sha',privprotocol=>'aes',username=>'username'
SetEnv[IP-addr_192]: MRTG_INT_IP="No Ip" MRTG_INT_DESCR="Avaya-Virtual-Services-Platform-7254XSQ---10GbLR-Port-1/1"
MaxBytes[IP-addr_192]: 1250000000
Title[IP-addr_192]: Traffic Analysis for 192 -- VSP7200
PageTop[IP-addr_192]: <h1>Traffic Analysis for 192 -- VSP7200</h1>
<div id=sysdetails> table stuff... not really needed??</div>


How do I add errors and discards to the above section?

I had this in the target before, and it was obviously broken. The check command threw all kinds of errors.

Code: Select all
Target[IP-Addr_192]: ifInErrors.192&ifOutErrors.192&ifOutDiscards.192&ifInDiscards.192&192:public@IP-addr:::::3


Ultimately, I'd like to have the following on one graph:
inErrors, outErrors, inDiscards, outDiscards, and in and out bandwidth.

Is this something I can do? Or do I need to have many sensors to do it?

Cheers,
cdcrawford
 
Posts: 1
Joined: Tue Oct 29, 2019 11:54 am

Re: MRTG and Nagios XI

Postby scottwilkerson » Wed Oct 30, 2019 2:40 pm

I'm going to preface my response with Nagios XI isn't going to know how to pull this information from the MRTG RRD unless you have craften another way, one is not builtin and I do not have a solution.

That said, I will show you the proper call for MRTG
Code: Select all
Target[IP-Addr_192]: InOctets.192&OutOctets.192&ifInErrors.192&ifOutErrors.192&ifOutDiscards.192&ifInDiscards.192:public@IP-addr:::::3
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
User avatar
scottwilkerson
DevOps Engineer
 
Posts: 17032
Joined: Tue Nov 15, 2011 3:11 pm
Location: Nagios Enterprises


Return to Nagios XI

Who is online

Users browsing this forum: No registered users and 9 guests