Monitor a linux mount point using NCPA

This support forum board is for support questions relating to Nagios XI, our flagship commercial network monitoring solution.
Locked
riahc3
Posts: 53
Joined: Thu Apr 05, 2018 9:36 am

Monitor a linux mount point using NCPA

Post by riahc3 »

We are monitoring serveral mount points on different servers

SRV1 SRV2 and SRV3

SRV1 is looking at /mount/SRV2 , /mount/SRV3 and the ncpa service

SRV2 is looking at /mount/SRV1, /mount/SRV3 and the ncpa service

SRV3 is looking at /mount/SRV1, /mount/SRV2 and the ncpa service


So, we we reboot server SRV1, we should get two non SRV1 realted errors in Nagios: The service /mount/SRV1 on SRV2 and the service /mount/SRV1 on SRV3 BUT we get a BUNCH of errors relating to other mount points and the NCPA service unrelated .

My coworker mentions that maybe SRV2 and SRV3 keeps attempting to remount /mount/SRV1 , it times out and it also times out the check. Could this be it? Should I increase the timeout the retry mount or/and the timeout for the check ?

Thank you
User avatar
mbellerue
Posts: 1403
Joined: Fri Jul 12, 2019 11:10 am

Re: Monitor a linux mount point using NCPA

Post by mbellerue »

What are the other errors that you're not expecting to get? Also what are your retry intervals set to right now?
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.

Be sure to check out our Knowledgebase for helpful articles and solutions!
Locked