z

Commercial Support Clients: Clients with support contracts can get escalated support assistance by visiting Nagios Answer Hub. These forums are for community support services. Although we at Nagios try our best to help out on the forums here, we always give priority support to our support clients.

[Nagios-devel] embedded-perl problem (bug?)

Support forum for Nagios Core, Nagios Plugins, NCPA, NRPE, NSCA, NDOUtils and more. Engage with the community of users including those using the open source solutions.

[Nagios-devel] embedded-perl problem (bug?)

Postby Guest » Thu Apr 18, 2002 8:35 am

Hi guys,

Nagios-1.0a7 segfaults without any error message when check_ifstatus.pl
is used. Nothing shows up when run, from the command line; only a
notification of SIGSEGV is shown in nagios.log.

I tried the same configuration over, after recompiling nagios -- now
without embedded-perl. This time all works fine. (probably this is not a
problem related to this specific plugin)

Nagios runs on a RedHat 7.2 i386 system.

The output from the plugin when run from the command line is:

Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
Use of uninitialized value in sprintf at ./check_ifstatus.pl line 148.
CRITICAL: host 'dummy-router', interfaces up: 40, down: 13, dormant:
0
ATM1/0.5-atm subif: down ->
ATM1/0.5-aal5 layer: down ->

ATM1/0.50-atm subif: down ->
ATM1/0.50-aal5 layer: down ->

Serial2/1: down -> === connection to IMEC ===
E1 4/3: down ->

E1 4/4: down ->
E1 4/5: down ->
E1 4/6: down ->
E1 4/7:
down ->
E1 4/0: down ->
E1 4/1: down ->
E1 4/2: down ->



I hope this can help you!
If not, please let me know how I can help to debug.
All suggestions are welcome!

Regards,
Guy










This post was automatically imported from historical nagios-devel mailing list archives
Original poster: guy.vandenbergh@belnet.be
Guest
 

Return to Open Source Nagios Projects

Who is online

Users browsing this forum: Google [Bot] and 22 guests