Support forum for Nagios Core, Nagios Plugins, NCPA, NRPE, NSCA, NDOUtils and more. Engage with the community of users including those using the open source solutions.
cdienger
Support Tech
Posts: 5045 Joined: Tue Feb 07, 2017 11:26 am
Post
by cdienger » Fri Sep 15, 2017 1:44 pm
I'd be curious to see what a tcpdump on the nagios server and on the destination server show. On the nagios side you can run:
Code: Select all
yum -y install tcpdump
tcpdump -i any host DESTINATION_IP and port 161
Assuming the other host is a linux variant and has tcpdump installed you can run this at the same time:
Code: Select all
tcpdump -i any host NAGIOS_IP and port 161
Run both of these while you run the snmpwalk and check commands.
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new
Privacy Policy .