Nagios Support Forum

Hi all,

I'm trying to find a way to check Avg. Disk Sec/Read and get a warning and critical notifications in ms.
How can i configure the next command with values in MS ?

./check_nt -H 10.0.0.21 -s "Test@193" -p 12489 -v COUNTER -l "\\PhysicalDisk(0 C:)\\Avg. Disk Sec/Read","%.2f"


Thanks

Hello,

I'm not exactly sure on what you mean in MS? Are you referring to adding this check into Nagios Core for monitoring?

Is MS suppose to mean Microsoft? Since check_nt is using NSClient++ which is for monitoring Windows. OR is ms suppose to mean get warning and critical notifications in milliseconds?

If you could give us some more detail on what you're wanting to do then I can let you know.

Hi,

So i would like to configure to Warning and Criticl values of the check in milliseconds.

Is it possible ?

amitw wrote:Hi,

So i would like to configure to Warning and Criticl values of the check in milliseconds.

Is it possible ?

So Avg. Disk Sec/Read displays the average time the disk transfers took to complete, in seconds, so if you wanted to warn over 4 milliseconds you would set warning to 0.0004

Thanks for the answer Scoot.

However, when i try to configure 0.1 on the warning and 0.2 and on critical values, it shows on the test result values of 0.0 for both critical and warning

./check_nt -H 10.60.30.2 -p 12489 -v COUNTER -l "\PhysicalDisk(_Total)\\Avg. Disk sec/Read","avg disk read is %.2f" -w 0.2 -c 0.1
avg disk read is 0.00 | 'avg disk read is %.2f'=0.000000%;0.000000;0.000000;

How it can be fixed ?

Thanks

Actually, my apologies, I just verified that in check_nt the warning and critical variables must be integers, so whole numbers only Sorry for leading you down the wrong path

Thanks Scoot,
Eventuality, i used check_nrpe

Good to hear

Locking