Hello
Can we monitor the hardware firewall by nagios core Version. If yes then please share the steps. thanks in advance.
Regards
Monitor hardware firewall by Nagios core
-
- DevOps Engineer
- Posts: 19396
- Joined: Tue Nov 15, 2011 3:11 pm
- Location: Nagios Enterprises
- Contact:
Re: Monitor hardware firewall by Nagios core
Yes but the possibilities vary based on your firewall.
Here some documentation
https://assets.nagios.com/downloads/nag ... uters.html
Additional plugins are available here
https://exchange.nagios.org/
Here some documentation
https://assets.nagios.com/downloads/nag ... uters.html
Additional plugins are available here
https://exchange.nagios.org/
Re: Monitor hardware firewall by Nagios core
Hello,
It is same configuration as we set configuration for the switch? I want to see only it is going to UP or DOWN.
Regards
It is same configuration as we set configuration for the switch? I want to see only it is going to UP or DOWN.
Regards
Re: Monitor hardware firewall by Nagios core
If I read your question right, you can use the same plugin to monitor the status of an interface for both a firewall and a switch.
All you need to to is to setup the SNMP community string, version and select the interface number and it should work for either device.
All you need to to is to setup the SNMP community string, version and select the interface number and it should work for either device.
Be sure to check out our Knowledgebase for helpful articles and solutions!