Hi!
How could I change the status from OK to WARNING / CRITICAL not the first time that obtain a value on waning / critical range, but the 3rd time for example?
Its with the retry_interval?
thanks in advanve!!!
Change the STATE after several results
-
- DevOps Engineer
- Posts: 19396
- Joined: Tue Nov 15, 2011 3:11 pm
- Location: Nagios Enterprises
- Contact:
Re: Change the STATE after several results
You cannot, however, the state will change from being in a SOFT state to a HARD state after reaching it's max_check_attempts which occur at retry_interval minutes.
Re: Change the STATE after several results
thanks a lot!
I suppossed that...
I suppossed that...
-
- DevOps Engineer
- Posts: 19396
- Joined: Tue Nov 15, 2011 3:11 pm
- Location: Nagios Enterprises
- Contact:
Re: Change the STATE after several results
No problemiam33 wrote:thanks a lot!
I suppossed that...
Locking thread