Monitor host with Ipv6

Engage with the community of users including those using the open source solutions.
Includes Nagios Core, Plugins, and NCPA

Monitor host with Ipv6

Postby Hanza » Tue Oct 05, 2021 4:52 pm

- I just started to work by nagios so I have some issues shows-up.
- We have in our envirement a printer has Ipv6, but nagios basically supervise hosts on Ipv4, I searched for a solution but non of them work for me.
Can you please help me?
Hanza
 
Posts: 7
Joined: Fri Dec 25, 2020 5:24 pm

Re: Monitor host with Ipv6

Postby gormank » Wed Oct 06, 2021 12:10 pm

Nagios doesn't much care if a host is v4 or v6 but for traps, you have to tell snmptrapd to listen for v6, either in snmptrapd.conf or (I think) /etc/sysconfig/snmptrapd.

One thing to be aware of is :: and :0: in the host address definition are probably not the same since Nagios treats addresses as strings.

If you can you snmpwalk the printer you should be able to do active SNMP checks on it as well.
gormank
 
Posts: 911
Joined: Tue Dec 02, 2014 12:00 pm


Return to Community Support

Who is online

Users browsing this forum: No registered users and 39 guests