I just started with nagios, and had a little bit of a bumpy start but it seems to go better now.
My first problem was with snmp but I managed to get it up and going on some of our switches.
But I have problem with A Cisco SG 300-20 switch.
With the Dlink switch I use GbE_XX and it works.
When I checked on my cacti installation i noticed that all the Description on the switch was "Ethernet Interface" while on the dlink switch it had the correct name.
check_snmp_int.pl -H my.ip.address.com -C public -n "Ethernet Interface"
It list all interfaces i dont have a way of separating them.. I only want to check a few ports.
This list all interface.
/check_snmp_int.pl -H my.ip.address.com -C public -n zzzz -v
Alarm at 15 + 5
SNMP v1 login
Filter : zzzz
OID : 1.3.6.1.2.1.2.2.1.2.300000, Desc : vlan
OID : 1.3.6.1.2.1.2.2.1.2.60, Desc : Ethernet Interface
OID : 1.3.6.1.2.1.2.2.1.2.100300, Desc : vlan
OID : 1.3.6.1.2.1.2.2.1.2.100019, Desc : vlan
OID : 1.3.6.1.2.1.2.2.1.2.100130, Desc : vlan
OID : 1.3.6.1.2.1.2.2.1.2.100004, Desc : vlan
Is there a way I can use the OID to instead of description?
Running it on a Ubuntu server 64bit, Nagios® Core™ 3.2.3