Nagios thinks 2 NICs are unplugged with Half-height blades

Post by **Box293** » Wed Mar 02, 2016 5:49 pm

delite wrote:I am able to see the vSphere Distributed Switch showing that vmnic0 / vmnic1 are connected and vmnic2 / vmnic3 are disconnected. I have the option to remove those dvUplinks that are disconnected. Would doing that also be a way of resolving this error?

Yes.

You should investigate why they are disconnected. Perhaps they are not used which is fine, but if they are not used they should not be assigned to the switch.

delite · Post by **delite** » Fri Mar 04, 2016 3:19 pm

Thank you for the help. Management decided upon just disable those NICs from the switch.

bwallace · Post by **bwallace** » Mon Mar 07, 2016 12:56 pm

Thanks for that update. Were there any other questions, or may we lock this thread?

delite · Post by **delite** » Tue Mar 08, 2016 9:52 am

I have no other questions. Thank you for the help.

bwallace · Post by **bwallace** » Tue Mar 08, 2016 10:04 am

Glad we were able to help. We'll lock this thread now and feel free to open another should you require assistance with anything else.

Nagios Support Forum

Nagios thinks 2 NICs are unplugged with Half-height blades

Re: Nagios thinks 2 NICs are unplugged with Half-height blad

Re: Nagios thinks 2 NICs are unplugged with Half-height blad

Re: Nagios thinks 2 NICs are unplugged with Half-height blad

Re: Nagios thinks 2 NICs are unplugged with Half-height blad

Re: Nagios thinks 2 NICs are unplugged with Half-height blad