nmpa command from nagios sercer itself:
-bash-4.1# nmap -sU -p 5666 168.162.97.143
Starting Nmap 6.47 ( http://nmap.org ) at 2017-03-20 10:53 EDT
mass_dns: warning: Unable to determine any DNS servers. Reverse DNS is disabled. Try using --system-dns or specify valid servers with --dns-servers
Nmap scan report for 168.162.97.143
Host is up (0.00023s latency).
PORT STATE SERVICE
5666/udp open|filtered unknown
Nmap done: 1 IP address (1 host up) scanned in 0.26 seconds
-bash-4.1# hostname
ssbpops01.ssb.sungard.com
-bash-4.1#
NRPE: Unable to read output
Re: NRPE: Unable to read output
Can you run this too since JMX is going to utilize this port directly?
Then, as requested, post the JMX configuration settings that are running on the client side.
Code: Select all
nmap -sU -p 7780 168.162.97.143
Former Nagios Employee
-
- Former Nagios Staff
- Posts: 4583
- Joined: Wed Sep 21, 2016 10:29 am
- Location: NoLo, Minneapolis, MN
- Contact: