For the below command i didn't receive any output it's showing "blank"
snmpwalk -v2c -c <SNMPstring> <ip address>|grep ifName
snmpwalk issue
-
- DevOps Engineer
- Posts: 19396
- Joined: Tue Nov 15, 2011 3:11 pm
- Location: Nagios Enterprises
- Contact:
Re: snmpwalk issue
That would lead me to believe that the switch either doesn't report IF-MIB::ifName at all, OR they are blocked in the SNMP configuration for your community string.manimurugesan wrote:For the below command i didn't receive any output it's showing "blank"
snmpwalk -v2c -c <SNMPstring> <ip address>|grep ifName
-
- Posts: 145
- Joined: Wed Oct 03, 2018 9:15 am
Re: snmpwalk issue
SNMP configuration for community string is fine .but could you please tell me how to check the IF-MIB::ifName from switch end ?
-
- DevOps Engineer
- Posts: 19396
- Joined: Tue Nov 15, 2011 3:11 pm
- Location: Nagios Enterprises
- Contact:
Re: snmpwalk issue
This is going to be switch dependent, you would need to reach out to the hardware vendor.manimurugesan wrote:SNMP configuration for community string is fine .but could you please tell me how to check the IF-MIB::ifName from switch end ?