The web interface shows alerts on some of our interface checks but the command line returns without error? So the web interface is not updating with the service check results.
OK: host '10.x.x.x, interfaces up: 3, down: 0, dormant: 0, excluded: 0, unused: 0 |up=3,down=0,dormant=0,excluded=0,unused=0
Service Status and Host Status not Updating after 1.3 Upgrad
-
slansing
- Posts: 7698
- Joined: Mon Apr 23, 2012 4:28 pm
- Location: Travelling through time and space...
Re: Service Status and Host Status not Updating after 1.3 Up
Could you post an image of the service status list that is not updating? Are you getting any sort of error on the Web UI? Will the service status page load?
Re: Service Status and Host Status not Updating after 1.3 Up
[img][/img]
The service check that isnt updating is RecoverpOint Interface Check
Page does load .....I had an issue after the upgrade to 1.3 this morning with host and service status not loading but I did a DB repair and that was rolsolved.
This started after a reboot of the server.
The service check that isnt updating is RecoverpOint Interface Check
Page does load .....I had an issue after the upgrade to 1.3 this morning with host and service status not loading but I did a DB repair and that was rolsolved.
This started after a reboot of the server.
You do not have the required permissions to view the files attached to this post.
Re: Service Status and Host Status not Updating after 1.3 Up
Is your issue resolved now or you still have problems?...but I did a DB repair and that was rolsolved...
Be sure to check out our Knowledgebase for helpful articles and solutions!
Re: Service Status and Host Status not Updating after 1.3 Up
It appears to be ok now.
Thanks
Thanks