Page 2 of 2
Re: NRPE Test
Posted: Mon Apr 15, 2013 11:21 am
by Pilly170
I have attached them above? (dropbox)
Can you not access them?
Re: NRPE Test
Posted: Mon Apr 15, 2013 11:25 am
by slansing
You are going to want to run the commands listed at the top of the nsclient.ini file in order to generate the full file, then you can define the handlers properly in the new sections generated.
Re: NRPE Test
Posted: Mon Apr 15, 2013 11:30 am
by Pilly170
Sorry Not sure I understand?
Re: NRPE Test
Posted: Mon Apr 15, 2013 11:41 am
by slansing
At the top of the NSclient.ini file you should see the following:
Code: Select all
# If you want to fill this file with all avalible options run the following command:
# nscp settings --generate --add-defaults --load-all
# If you want to activate a module and bring in all its options use:
# nscp settings --activate-module <MODULE NAME> --add-defaults
# For details run: nscp settings --help
In order to reveal the entire configuration file you must run the commands listed, if they are not present you may want to either upgrade, or downgrade to 0.3.9 as there may be a bug in the version you have.. did you by chance download one of the Nightly Build's?