Nagios Support Forum

here is what iv got ...

root@nagios:~# snmptranslate .1.3.6.1.2.1.1.3 -m /usr/share/snmp/mibs/SNMPv2-MIB.my
No log handling enabled - turning on stderr logging
/usr/share/snmp/mibs/SNMPv2-MIB.my: No such file or directory
iso.3.6.1.2.1.1.3
root@nagios:~#

Try this path:

here it is ....

root@nagios:~# snmptranslate .1.3.6.1.2.1.1.3 -m /usr/share/mibs/netsnmp/SNMPv2-MIB.my
SNMPv2-MIB::sysUpTime
root@nagios:~#

So your mib is there and working. When doing a walk ir translating a trap, make sure to specify the whole path.

When doing a walk ir translating a trap, make sure to specify the whole path.

Im a little confused now .... can you gave me some directions or example .....

It is quite odd that your mib directory: Is listed in the mib search path, but is not found by translate, walks or gets. You may have to specify the full path to the mib when performing a check that requires said mib. For example:

Here it is the output

root@nagios:~# snmpget -v 2c -c MyCom1 172.25.1.101 sysUpTime.0 -m /usr/share/mibs/netsnmp/SNMPv2-MIB.my
SNMPv2-MIB::sysUpTime.0 = Timeticks: (8854816) 1 day, 0:35:48.16
root@nagios:~#

.... so if i understand ok, My mibs are in this placeses

• /usr/share/mibs/iana
  /usr/share/mibs/ietf
  /usr/share/mibs/netsnmp

So how to make all in one folder and all scripts or snmpget to get the info about mibs in that folder or something like that .....

That is the issue, as those directories are already in your path and yet, unless we declare the full path to the mib, the commands are not finding the mibs.

Ok that was my question .... how to declare the full path to the mib's and to be just one path, one directory or something like that .... or to delete the other empty paths or paths that are not used .......

The empty paths don't hurt as it will procedurally search through each one for the necessary mib. If you look at the last path in the default directories below, it is the right path.