Nagios Support Forum

OUTPUT: Usage: check_snmp_storage [-v] -H -C [-2] | (-l login -x passwd [-X pass -L ,]) [-p ] -m [-q storagetype] -w -c [-t ] [-T pl|pu|bl|bu ] [-r -s -i -G] [-e] [-S 0|1[,1,]] [-o ] [-R

There's the problem, although if this was from a wizard it should not have done this. Go into the CCM and modify the arguments for this command to have everything in $ARG1$. Your arg1 should look like:

well now we are making some progress but now i have another problem

COMMAND: /usr/local/nagios/libexec/check_snmp_load.pl -H oak-fs1 -C password --v2c -m \^C: -w 80 -c 95 -f
OUTPUT: ERROR: Description table : No response from remote host 'oak-fs1'.

Just to verfiy, and you may have previously, is this host configured in the properties of the snmp service to respond to the nagios server? Also lets make sure that its up and running, the command below should respond with open, not filtered if it is done correctly.

guess it is not done correctly because it shows as filtered snmp. So the question is now how do i change that?

It is filtered by one of:
Networking device - like a router/firewall
Software firewall on remote host - like windows firewall or linux iptables

All of these potential causes are environment specific. Looks like it is a 2003 windows server (judging form one of your previous messages). You will need to enable snmp and verify that the service is started:
http://support.microsoft.com/kb/324263

yes it is a 2003 box but snmp is running and is being used by other monitoring software with no problems. Why is it not working with the nagios server?

Is your XI box on the same network node as the 2003 server (and the other snmp monitors)? (it could be a networking device between them)

Update: I just tried snmp on a switch and it worked just fine. Do you have any ideas now why it would not be working on servers?

What version of snmp is the server using? Again, if the port is reported as filtered, there must be a software/hardware firewall issue.
Is the 2003 server on the same network node / subnet as the nagios server or the currently working switch?