Page 2 of 2
Re: website wizard for ssl only sites
Posted: Wed Apr 04, 2012 7:36 am
by johndoe
I'm having the exact same problem, HTTPS only url's don't work.
The HTTP service check works fine but the host check shows me "CRITICAL - Socket timeout after 10 seconds"
Re: website wizard for ssl only sites
Posted: Wed Apr 04, 2012 1:43 pm
by scottwilkerson
johndoe,
Can you show us your settings in the
Service Status -> Configure Tab -> Re-configure this host -> Monitoring Tab
Re: website wizard for ssl only sites
Posted: Thu Apr 05, 2012 2:02 am
by johndoe
Monitor the host every 5 minutes.
Re-check the host every 1 minutes up to 5 times before generating an alert.
Monitor the host with this command... (Advanced users only)
(empty) <- It shouldn't be since the wizard should've specified here it was an https check
When I add the same that is on the HTTP check (check_xi_service_http! -H <fqdn> -f ok -I <ip> -u "/" -S -p 443) then the check runs with HTTPS
I guess the problem is on the wizard not adding all the needed args on the monitor command?
Re: website wizard for ssl only sites
Posted: Thu Apr 05, 2012 7:48 am
by scottwilkerson
johndoe wrote:I guess the problem is on the wizard not adding all the needed args on the monitor command?
Yep, that was it.
I modified the wizard (attached) to have the expected behavior on new websites added.
You can add it through Admin -> Manage Config Wizards