Page 2 of 2
Re: Switch wizard pre-populates wrong data
Posted: Fri Feb 27, 2015 2:36 pm
by tbmay
24...that's the confusing part. And the link speed shouldn't be this low. See attachment.
Re: Switch wizard pre-populates wrong data
Posted: Fri Feb 27, 2015 3:07 pm
by abrist
Is there a bandwidth statement on the device side?
Can you post the relevant portion of the mrtg config for this port?
Re: Switch wizard pre-populates wrong data
Posted: Sat Feb 28, 2015 10:59 am
by tbmay
Please find the attachment.
Re: Switch wizard pre-populates wrong data
Posted: Mon Mar 02, 2015 10:16 am
by tbmay
I don't set the switches up, but I wouldn't think a bandwidth statement would have been expressly set. Please find the attached file for review.
Re: Switch wizard pre-populates wrong data
Posted: Mon Mar 02, 2015 10:33 am
by tbmay
Also, I can't get into tracker.nagios.com.
Thanks again.
Re: Switch wizard pre-populates wrong data
Posted: Mon Mar 02, 2015 5:49 pm
by cmerchant
You need to register for separate access to the tracker:
http://tracker.nagios.com/signup_page.php