Page 2 of 2
Re: Configuring First Plugin - New to Nagios
Posted: Wed Jun 17, 2015 1:33 pm
by tmcdonald
Now that it can work from the command line, this guide was written specifically to guide users from initial upload to final configuration of the plugin:
https://assets.nagios.com/downloads/nag ... ios-XI.pdf
Re: Configuring First Plugin - New to Nagios
Posted: Wed Jun 17, 2015 2:34 pm
by angus
I have been successfully testing commands. My main goal is to get Volume disk usage percentage. Is there a way to get that with this plugin? If you can tell please walk me through the process so I can understand for the future. My command and output is below.
[root@X libexec]# ./check_netapp3.pl -H X.X.X.X-o Vol0 -v DISKUSED
DISKUSED OK - Vol0 Checks OK|
Also now that we have this working how to a make it work in XI?
Thanks.
Re: Configuring First Plugin - New to Nagios
Posted: Wed Jun 17, 2015 3:15 pm
by angus
I didn't see your latest post due to not realizing we ran over to page 2. I have the command working in XI but the output isn't very useful. Are there ways to tweak the output to disk used %? should I explore a different plugin at this point?
Thanks.
Re: Configuring First Plugin - New to Nagios
Posted: Wed Jun 17, 2015 3:22 pm
by jolson
Is there any flag in the plugin that might be able to change the output? If not, I'm sure there are more plugins you could test out.
https://exchange.nagios.org/directory/P ... NAS/NetApp