Nagios Support Forum

Posted: **Fri May 05, 2017 1:18 pm**

lmiltchev wrote:Are you using modgearman or livestatus?

I use mod_gearman

lmiltchev wrote:I am sure you updated your plugin as the output in the CLI that you showed us is correct. Also, your service definition is valid. I would assume that you haven't changed the default command definition for the "check_xi_ncpa" command, have you? Can you show it, along with the output of the command below?
Code: Select all
/usr/local/nagios/libexec/check_ncpa.py -V

Code: Select all

[root@servername ~]# /usr/local/nagios/libexec/check_ncpa.py -V
check_ncpa.py, Version 1.1.1

lmiltchev wrote:If you are using modgearman, it is possible that the job is picked up by the worker, but the NCPA plugin hasn't been updated on the worker machine.

That the solution... I don't remember that particularity.

Before updating all worker...

Code: Select all

[root@worker1 libexec]# ./check_ncpa.py -V
check_ncpa.py, Version 1.0.2

Code: Select all

[root@worker1 libexec]# ./check_ncpa.py -V
check_ncpa.py, Version 1.0.2

Now I see all the services

Thank you a lot for helping. You can also close that thread

Nagios Support Forum

NCPA Check see only one result instead of 3.

Re: NCPA Check see only one result instead of 3.