Nagios Support Forum

I am getting this when the installation finishes


################################################################################
### ###
grep: /etc/xinetd.d/nrpe: No such file or directory
### NRPE is currently set to allow connections only from these IP addresses: ###
### ###
### ###
### ###
### If you would like to change this list, enter all IP addresses to allow, ###
### separated by spaces only, and then press Enter. ###
### (Put the address(es) of your Nagios XI servers(s) here.) ###
### ###
################################################################################

Allow from: 10.2.40.4
sed: can't read /etc/xinetd.d/nrpe: No such file or directory

Stopping xinetd: [ OK ]
Starting xinetd: [ OK ]
/tmp/linux-nrpe-agent-el4
A-subcomponents appears to have already completed successfully. Moving on to the next step.

jcamillo wrote:/tmp/linux-nrpe-agent-el4

Again, like I said before it looks like you are using the wrong install file, this one is for centOS 4:

scottwilkerson wrote:For RHEL/CentOS 5-6 (el5 & el6) the install file should be:

Code: Select all

# wget http://assets.nagios.com/downloads/nagiosxi/agents/linux-nrpe-agent.tar.gz

Detailed install instructions may be found here
Installing_The_XI_Linux_Agent

So for version (gcc version 4.4.4 20100726 (Red Hat 4.4.4-13) (GCC) I should be using install file

For RHEL 4 & CentOS 4 (el4):
# wget http://assets.nagios.com/downloads/nagi ... el4.tar.gz

That's the compiler version.
Your Redhat version, I'm guessing is 6 by the kernel you are running contains el6

run:

Im still having trouble with some installs. Is there an error log on the client side I can look at?

I am getting - " bash-4.1# /usr/local/nagios/libexec/check_nrpe -H 50.17.70.222
Connection refused by host
-bash-4.1#


Thanks
Joe

First I would check to see if to see if nrpe is running on 50.17.70.222

From the terminal on 50.17.70.222
Then I would look for any nrpe related errors with If all that looks good, I would look at possible firewall/iptables problems.