Page 2 of 2
Re: specific metric selection (check_esx3) delet parameter g
Posted: Tue Feb 19, 2013 10:05 am
by yancy
mauricio,
What is the error you receive when you use other subcommands like -s swap ?
-Yancy
Re: specific metric selection (check_esx3) delet parameter g
Posted: Tue Feb 19, 2013 10:55 am
by mauricio.moya
That when I add memory variables (swap, usage, etc...) with Critical and warning definition, means that i have to add new services. One for swap, other for usage, etc.
But when i add as a Memory i see all of them in one services.
Re: specific metric selection (check_esx3) delet parameter g
Posted: Tue Feb 19, 2013 1:30 pm
by lmiltchev
If you would like to use a sub-commands, you will have to set up different checks. I don't think you can do this in "one go" with using "-w" and "-c" flags.
Re: specific metric selection (check_esx3) delet parameter g
Posted: Wed Feb 20, 2013 8:08 am
by mauricio.moya
That what I suspect...
Ok thanks!