Page 2 of 6
Re: Need plugin information
Posted: Fri Feb 08, 2013 10:41 am
by ravish78
Yes ,we did the same but no luck
Re: Need plugin information
Posted: Fri Feb 08, 2013 10:56 am
by abrist
Could you post your nsc.ini in a code wrap? (obfuscate your password)
Re: Need plugin information
Posted: Mon Feb 11, 2013 4:41 pm
by CGraham
ravish78,
Just curious if the command works when you run it with the "-n" switch
Code: Select all
./check_nrpe -H 13.118.27.40 -n -p 5666 -t 30 -c checkMem -a MaxWarn=80% MaxCrit=90% ShowAll=long type=physical
Have you disabled ssl in your nsc.ini?
use_ssl=0
Re: Need plugin information
Posted: Mon Feb 11, 2013 5:50 pm
by lmiltchev
Yes, run the command with the "-n" flag as subbested by ravish78, and post the output.
Also, check the nsclient.log again - there may be some new entries in it.
Re: Need plugin information
Posted: Mon Feb 18, 2013 1:32 pm
by ravish78
tmproot@usa0300lv846>./check_nrpe -H 13.118.27.40 -n -p 5666 -t 30 -c checkMem -a MaxWarn=80% MaxCrit=90% ShowAll=long type=physical
CHECK_NRPE: Received 0 bytes from daemon. Check the remote server logs for error messages.
tmproot@usa0300lv846>
getting below error in clinet system nagois log
tmproot@usa0300lv846>./check_nrpe -H 13.118.27.40 -n -p 5666 -t 30 -c checkMem -a MaxWarn=80% MaxCrit=90% ShowAll=long type=physical
CHECK_NRPE: Received 0 bytes from daemon. Check the remote server logs for error messages.
tmproot@usa0300lv846>
Re: Need plugin information
Posted: Mon Feb 18, 2013 1:40 pm
by scottwilkerson
Could you post your nsc.ini blocking out any sensitive data
Also, are there any errors in the nsclient.log on the remote system?
Re: Need plugin information
Posted: Mon Feb 18, 2013 2:07 pm
by CGraham
Also, you have to restart nsclient++ service for the changes in your ini to take effect.
Re: Need plugin information
Posted: Mon Feb 18, 2013 2:40 pm
by ravish78
I am only seeing this error.
2013-02-18 11:14:08: debug:CACHENSClient++.cpp:557: Attempting to start NSCLient++ - 0.3.9.329 2011-09-02
2013-02-18 11:14:08: message:CACHEmodules\FileLogger\FileLogger.cpp:87: Log path is: C:\NSClient++\\nsclient.log
2013-02-18 11:14:08: error:modules\NSClientListener\NSClientListener.cpp:160: Invalid password (
2013-02-18 13:31:16: error:modules\NSClientListener\NSClientListener.cpp:160: Invalid password (
2013-02-18 14:39:49: message:modules\FileLogger\FileLogger.cpp:86: Starting to log for: NSClient++ - 0.3.9.329 2011-09-02
Re: Need plugin information
Posted: Mon Feb 18, 2013 2:50 pm
by scottwilkerson
Could you post your nsc.ini blocking out any sensitive data
Re: Need plugin information
Posted: Mon Feb 18, 2013 3:59 pm
by ravish78
How can we test this blocking