Page 3 of 3
Re: Setting up monitoring using templates
Posted: Fri Sep 01, 2017 2:34 pm
by cdienger
You can use a program like WinSCP to connect to the service and copy the file over.
Re: Setting up monitoring using templates
Posted: Fri Sep 01, 2017 3:08 pm
by chelch
File attached
Re: Setting up monitoring using templates
Posted: Fri Sep 01, 2017 4:00 pm
by cdienger
Thanks! Got the file and the config looks good but for some reason it doesn't appear to be running. Can you also take a look at
/usr/local/nagios/var/status.dat ? Ideally, just search for the DEN-WBS-PDEV02 host and post its details. It should be in a section that looks like:
Code: Select all
hoststatus {
host_name DEN-WBS-PDEV02....
morestuff
...
morestuff
}
Review the content before posting it as it may contain sensitive info.
Re: Setting up monitoring using templates
Posted: Tue Sep 05, 2017 12:03 pm
by chelch
File attached
Re: Setting up monitoring using templates
Posted: Tue Sep 05, 2017 12:46 pm
by scottwilkerson
chelch wrote:File attached
This appears correct, is this host still showing grey in the UI?
Re: Setting up monitoring using templates
Posted: Tue Sep 05, 2017 1:35 pm
by chelch
Yes..still status of pending and status information of host check is pending.
Re: Setting up monitoring using templates
Posted: Tue Sep 05, 2017 1:43 pm
by scottwilkerson
chelch wrote:Yes..still status of pending and status information of host check is pending.
I actually think we may need ot do a remote session to try to figure this issue out
Can you open a ticket by emailing
[email protected] and reference this thread and we can set something up to expedite support of this issue
Re: Setting up monitoring using templates
Posted: Tue Sep 05, 2017 5:39 pm
by chelch
email sent
Re: Setting up monitoring using templates
Posted: Wed Sep 06, 2017 9:08 am
by tmcdonald
Ticket received, we will continue via email.