Page 4 of 5
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Thu Oct 13, 2011 11:51 am
by brian.gamble
Ok, thanks for the update.
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Fri Oct 14, 2011 2:26 pm
by nscott
brian,
I updated the Nagios Wiki, please read the section:
http://support.nagios.com/wiki/index.ph ... ve_No_Data
Its short and sweet.
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Sat Oct 15, 2011 7:31 am
by brian.gamble
Ok, I tried to create the MRTG directory just to be sure and it said it already existed.
The SNMP version that MRTG is polling is set to 1 as indicated by the :::::1 so it's not a ver. 2c issue.
Should I set it to ver. 2 and see what happens?
Also, my admin password has a - (dash) in it which the wiki suggests could cause permissions/graphing problems. I'll change this as well.
Thanks
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Sat Oct 15, 2011 8:28 am
by brian.gamble
Tried SNMP v2 as well as changed all my password to ONLY be alpha numeric as suggested in the Wiki yet I'm still not able to see data on those ports.
Please advise
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Mon Oct 17, 2011 10:34 am
by nscott
brian,
I sent you an email.
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Wed Oct 19, 2011 5:17 pm
by brian.gamble
Not sure what you did when you remoted in but it works. Would you mind sharing what you did to resolve? Thanks!
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Wed Oct 19, 2011 5:28 pm
by nscott
Of course, I'm writing something up to put on the wiki, but what happened is there are some growing pains with Nagios XI and CentOS 6 and one of the minor dependencies wasn't install: bc. What I did was yum install bc, which allowed the check_rrdtraf plugin to function properly, and thats all it was.
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Wed Nov 16, 2011 2:21 pm
by brian.gamble
After updating to 1.8, I'm having the same issue. Please help!
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Thu Nov 17, 2011 10:30 am
by mguthrie
Take a look at the following wiki and see if it resolves your issue.
http://support.nagios.com/wiki/index.ph ... h_Problems
Re: Unable to get bandwidth utilization data from Cisco swit
Posted: Thu Nov 17, 2011 11:04 am
by brian.gamble
I had already tried this with no success.