Page 5 of 5
Re: Regarding Tunnel interface graph not polling
Posted: Thu Oct 10, 2019 10:33 am
by inshad
its working after the changes but some of the tunnel performance data value not correct whether any way to correct?
Re: Regarding Tunnel interface graph not polling
Posted: Thu Oct 10, 2019 3:25 pm
by benjaminsmith
Hello
@inshad,
Can you provide some specifics about which values are not correct? You can view the plugin output for performance data from the
Advanced Tab under host or service details.
perd-data-ouput.png
Re: Regarding Tunnel interface graph not polling
Posted: Thu Oct 10, 2019 3:54 pm
by inshad
Dear
kindly find the snapshot
Re: Regarding Tunnel interface graph not polling
Posted: Fri Oct 11, 2019 12:22 pm
by tgriep
The screen capture shows 20 Megabits in and 86 Megabits out, what do you feel they should be?
Re: Regarding Tunnel interface graph not polling
Posted: Fri Oct 11, 2019 12:26 pm
by inshad
My actual traffic on the tunnel more than 200 mbps which is not showing on nagios
Re: Regarding Tunnel interface graph not polling
Posted: Fri Oct 11, 2019 1:43 pm
by tgriep
The data is off by a factor of 10, correct?
In the post from Wed Oct 09, 2019 2:35 pm, I had you change this option.
MaxBytes[188.231.3.149_40]: 125000000
This is used to calculate the speed on an interface.
Adjust the settings of that option to get the required results.
Remember, you will have to delete the rrd and xml files and wait for the data to be captured.