Re: [Nagios-devel] Config listed twice
Posted: Sun May 04, 2008 11:23 am
Hi Bernd,
Bernd Arnold schrieb:
> Hi,
>
> I've compiled amd installed a fresh Nagios 3.0.1, just to be sure. In the Nagios web interface, the Config page (config.cgi) shows all entries twice (hosts, services, ...). In my fresh installation, there are two lines with "localhost" for example.
>
> I've done some testing, and the error was gone when the line 126 in config.cgi (current version in CVS rev. 1.46 with the call of read_all_object_configuration_data) is set to comment, also the following if-clause of course (lines 127-132).
>
This has been fixed in CVS a few weeks ago.
-
Hendrik
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]
Bernd Arnold schrieb:
> Hi,
>
> I've compiled amd installed a fresh Nagios 3.0.1, just to be sure. In the Nagios web interface, the Config page (config.cgi) shows all entries twice (hosts, services, ...). In my fresh installation, there are two lines with "localhost" for example.
>
> I've done some testing, and the error was gone when the line 126 in config.cgi (current version in CVS rev. 1.46 with the call of read_all_object_configuration_data) is set to comment, also the following if-clause of course (lines 127-132).
>
This has been fixed in CVS a few weeks ago.
-
Hendrik
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]