[Nagios-devel] NAS400 Plug in
Posted: Thu Oct 14, 2004 1:54 am
Hi!
I=B4m using nas400 plugin for nagios, now i have some trouble with our =
OPs
Each process causes a log entry into the MSG from the as/400... For now =
i check it each minute,
at first i set it to 15 minutes. But thats not the solution i think
Isnt it possible to keep connection alive and refresh the view to get =
the values??
Oh i mean for now the CPU Load of the machine.
Second question, is it possible to add a feature for check the status of =
an message (0-99) ?
There are a lot of messages but only the messages above a value of '50' =
or above are critical for us, the
rest is uninterested
Thanks for any help!!!
Bye
Andreas W.
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]
I=B4m using nas400 plugin for nagios, now i have some trouble with our =
OPs
Each process causes a log entry into the MSG from the as/400... For now =
i check it each minute,
at first i set it to 15 minutes. But thats not the solution i think
Isnt it possible to keep connection alive and refresh the view to get =
the values??
Oh i mean for now the CPU Load of the machine.
Second question, is it possible to add a feature for check the status of =
an message (0-99) ?
There are a lot of messages but only the messages above a value of '50' =
or above are critical for us, the
rest is uninterested
Thanks for any help!!!
Bye
Andreas W.
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]