[Nagios-devel] check_disk -e/-q
Posted: Tue Jun 17, 2003 12:47 pm
The output of check_disk -h includes:
-e, --errors-only
Display only devices/mountpoints with errors
The program doesn't understand the -e flag. It does understand -q but
doesn't mention it in the -h output. The above should probably be replaced
with
-q, --quiet
Display only devices/mountpoints with errors
FYI.
--
Skip Montanaro
[email protected]
Got spam? http://spambayes.sf.net/
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]
-e, --errors-only
Display only devices/mountpoints with errors
The program doesn't understand the -e flag. It does understand -q but
doesn't mention it in the -h output. The above should probably be replaced
with
-q, --quiet
Display only devices/mountpoints with errors
FYI.
--
Skip Montanaro
[email protected]
Got spam? http://spambayes.sf.net/
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]