Nagios Support Forum

Hello,

Whilst doing some testing on Nagios 4 I noticed that check commands with
arguments containing sequential backslashes are unescaped twice.

In Nagios 3, the following check_command:

check_nrpe!CheckCounter!ShowAll "Counter:Processor Time
(%)=\\\\Processor(_Total)\\% Processor Time"

is executed as:

check_nrpe -H foobar -a CheckCounter -c 'ShowAll "Counter:Processor Time
(%)=\\Processor(_Total)\% Processor Time"'

However in Nagios 4 it is executed as:

check_nrpe -H foobar -a CheckCounter -c 'ShowAll "Counter:Processor Time
(%)=\Processor(_Total)% Processor Time"'

This is due to the backslash being unescaped in base/utils.c around line
638 [1] and again in lib/runcmd.c around line 153 [2].

I fixed this by removing the escape code in lib/runcmd.c, but I have my
doubts about whether it is the correct solution.

Any thoughts?

Cheers,

Adam

[1] https://github.com/ageric/nagios/blob/m ... cmd.c#L153
[2] https://github.com/ageric/nagios/blob/m ... ils.c#L638
--
Open Source Consultant, Transitiv Technologies Ltd.

Business Critical Support and Services for Open Source Software.

T: 0203 384 7207
E: [email protected]
W: http://www.transitiv.co.uk





This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]