[Nagios-devel] Perfdata handling
Posted: Thu May 19, 2005 10:03 am
Hi List!
I experienced the same situation what Tedman Eng wrote to the user list at
Mon, 11 Oct 2004 23:36:53 -0700:
"I noticed that when switching from originally not using perfdata and then
later started wanting to use perfdata, I had to clear out the status.sav
before the perfdata commands became active. I'm guessing that the original
perfdata state, "process perf_data 0", got saved in the retention file,
which does not automatically toggle even after changing to
"process_perf_data 1" in the config file."
I use Nagios 1.2 on Debian Woody 3.1.
I hope this bug is resolved in Nagios 2.0. If not I just would like to note
it and I hope someone can fix it.
Bye, Tamas!
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]
I experienced the same situation what Tedman Eng wrote to the user list at
Mon, 11 Oct 2004 23:36:53 -0700:
"I noticed that when switching from originally not using perfdata and then
later started wanting to use perfdata, I had to clear out the status.sav
before the perfdata commands became active. I'm guessing that the original
perfdata state, "process perf_data 0", got saved in the retention file,
which does not automatically toggle even after changing to
"process_perf_data 1" in the config file."
I use Nagios 1.2 on Debian Woody 3.1.
I hope this bug is resolved in Nagios 2.0. If not I just would like to note
it and I hope someone can fix it.
Bye, Tamas!
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]