Nagios Support Forum

Hi Hendrik,

you are right, when i delete the retention.dat file and make a clean start, then
no service checks are executed.
So it has something to do with the retention data...

Sven


Hendrik Baecker wrote:
> Hi Sven,
>
> didn't test this up to now, but from Nagios2.x there some situations
> where the retention files are causing some trouble in the sense of
>
> configuration says yes to something
> retention says no
>
> ergo: no
>
> Did you delete your retention file and start from scratch?
>
> Regards
> Hendrik
>
>
> Sven Nierlein schrieb:
>> Hi,
>>
>> After upgrading to 3.0a5, i noticed, that active service checks are executed, even if
>> active checks are disabled in nagios.cfg.
>>
>> I have set
>> execute_service_checks=0
>> on my standby installation and checked this setting on the "process info" page, but
>> some active servicecheck have been executed (not all services, but some).
>>
>> I tried to disable some settings which i thought they could interfere the execution.
>> check_for_orphaned_services=0
>> check_for_orphaned_hosts=0
>> check_service_freshness=0
>> But these settings didn't change the behavior.
>>
>> Can anyone reproduce this or has a solution?
>>
>> Sven


--
Sven Nierlein [email protected]
ConSol* GmbH http://www.consol.de
Franziskanerstrasse 38 Tel.:089/45841-439
81669 Muenchen Fax.:089/45841-115





This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]