[Nagios-devel] Missing group in Makefile
Posted: Wed Jun 13, 2007 8:08 am
Hi list,
this is my first contribution so please inform me of any rules/speficitatio=
n I might violate.
I encountered an inconsistency while trying to install nrpe-2.8.1.=20
I configured with the option --nagios-group=3Dnagios. While configure runs =
fine it does not state the group at the final configure options that are =
shown when configure is done.
The group name shows up emtpy.
Also make runs fine with missing group the command make install-plugins =
stops with an error. This is due to the group not been set and so the =
syntax does not come out right.
Editing the Makefile in the src/ directory and entering the right =
groupname in line 27 before the make solves the problem.
Just a minor thing, but might prevent some less experienced user from =
using nrpe.=20
Hope this is not the second time this error is reported.
Regards Sascha M=FCller
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]
this is my first contribution so please inform me of any rules/speficitatio=
n I might violate.
I encountered an inconsistency while trying to install nrpe-2.8.1.=20
I configured with the option --nagios-group=3Dnagios. While configure runs =
fine it does not state the group at the final configure options that are =
shown when configure is done.
The group name shows up emtpy.
Also make runs fine with missing group the command make install-plugins =
stops with an error. This is due to the group not been set and so the =
syntax does not come out right.
Editing the Makefile in the src/ directory and entering the right =
groupname in line 27 before the make solves the problem.
Just a minor thing, but might prevent some less experienced user from =
using nrpe.=20
Hope this is not the second time this error is reported.
Regards Sascha M=FCller
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]