Re: [Nagios-devel] Nagios 3.0b1 not processing scheduling queue /
Posted: Thu Aug 23, 2007 5:56 am
> Can you try:
>=20
> 1. Enabling debug options
> 2. Running Nagios as a foreground process instead of a daemon
>=20
> This should help track down the problem, and ensure that=20
> Nagios didn't silently die from a segfault.
Thanks, this helped a lot
What showed up was that some defined commands were not available in the
new installation and gave us a "command not found" (reported to stdout).
Once these were available again, everything seems to be running along.
So perhaps there's a problem on Solaris on forking the commands?
Anyway, now it is running it seems it leaves a few files in /tmp called
* checkl7ii2p
* checklBgi2p
And so on, one or two every minute.
Anything we can do to have it clean up after itself?
Regards,
Steffen
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]
>=20
> 1. Enabling debug options
> 2. Running Nagios as a foreground process instead of a daemon
>=20
> This should help track down the problem, and ensure that=20
> Nagios didn't silently die from a segfault.
Thanks, this helped a lot
What showed up was that some defined commands were not available in the
new installation and gave us a "command not found" (reported to stdout).
Once these were available again, everything seems to be running along.
So perhaps there's a problem on Solaris on forking the commands?
Anyway, now it is running it seems it leaves a few files in /tmp called
* checkl7ii2p
* checklBgi2p
And so on, one or two every minute.
Anything we can do to have it clean up after itself?
Regards,
Steffen
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]