Re: [Nagios-devel] cvs help
Posted: Thu Nov 28, 2002 6:29 pm
No stupid questions..
You only need to run both commands the first time. All subsequent runs o=
n=20
the same system can just run the second command to get the latest files.
(cvs keeps a ~/.cvspass for the login info)
then run configure and make as usual.
-sg
On Fri, 29 Nov 2002, Tom Welsh wrote:
> Hi Chaps,
> =20
> Sorry bout this lame ass request but im a great believer in asking
> =93stupid =93 questions so here goes
> =20
> I=92ve never used cvs before so I was wondering if it is just runn the =
2
> commands from the CVS page on www.nagios.org
> to get the current source then just a make , make all, make install
> sequence.=20
> =20
> Is that correct, will I then have all the latest up2date code?
> =20
> Cheers for your help and this great program
> =20
> Thanks
> Tom Welsh
> [email protected]
> =20
>=20
--=20
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]
You only need to run both commands the first time. All subsequent runs o=
n=20
the same system can just run the second command to get the latest files.
(cvs keeps a ~/.cvspass for the login info)
then run configure and make as usual.
-sg
On Fri, 29 Nov 2002, Tom Welsh wrote:
> Hi Chaps,
> =20
> Sorry bout this lame ass request but im a great believer in asking
> =93stupid =93 questions so here goes
> =20
> I=92ve never used cvs before so I was wondering if it is just runn the =
2
> commands from the CVS page on www.nagios.org
> to get the current source then just a make , make all, make install
> sequence.=20
> =20
> Is that correct, will I then have all the latest up2date code?
> =20
> Cheers for your help and this great program
> =20
> Thanks
> Tom Welsh
> [email protected]
> =20
>=20
--=20
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]