NagiosXI VM hanging?
Posted: Fri Feb 14, 2014 7:16 am
Hi there guys,
Apologies if this has been posted somewhere before, I have had a hunt through the forum but can't quite see the same issue I am having so thought I'd just post and try!
I have installed the Nagios XI pre-built VM (nagiosxi-2012r2.8c-64.ova) on to our virtual environment and although had a few issues getting it on the network (I did have to remove a couple of lines from ifcfg-eth0 and have posted what it currently looks like a the bottom of this post) however it seems to be up and running OK now however when I go to the IP through a web browser I get the welcome to Nagios screen but when I click the "Access Nagios XI" link that takes me to http://ipaddress/nagiosxi then the browser just opens a blank page, it doesn't look like it is stuck loading as there is the refresh option rather than stopping the page loading. I've tried it in Chrome and IE with no joy so don't think it's a browser problem.
Any thoughts/ideas would be much appreciated?
Thanks
John
ifcfg-eth0 current contents:-
DEVICE=eth0
NM_CONTROLLED=yes
ONBOOT=yes
TYPE=Ethernet
BOOTPROTO=none
DEFROUTE=yes
PEERROUTES=yes
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
IPADDR=blah blah
NETMASK= blah blah
GATEWAY= blah blah
USERCTL=no
Apologies if this has been posted somewhere before, I have had a hunt through the forum but can't quite see the same issue I am having so thought I'd just post and try!
I have installed the Nagios XI pre-built VM (nagiosxi-2012r2.8c-64.ova) on to our virtual environment and although had a few issues getting it on the network (I did have to remove a couple of lines from ifcfg-eth0 and have posted what it currently looks like a the bottom of this post) however it seems to be up and running OK now however when I go to the IP through a web browser I get the welcome to Nagios screen but when I click the "Access Nagios XI" link that takes me to http://ipaddress/nagiosxi then the browser just opens a blank page, it doesn't look like it is stuck loading as there is the refresh option rather than stopping the page loading. I've tried it in Chrome and IE with no joy so don't think it's a browser problem.
Any thoughts/ideas would be much appreciated?
Thanks
John
ifcfg-eth0 current contents:-
DEVICE=eth0
NM_CONTROLLED=yes
ONBOOT=yes
TYPE=Ethernet
BOOTPROTO=none
DEFROUTE=yes
PEERROUTES=yes
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
IPADDR=blah blah
NETMASK= blah blah
GATEWAY= blah blah
USERCTL=no