Page 1 of 1
Firewall Monitoring
Posted: Wed Mar 05, 2014 1:10 am
by deepavaidya
Hi,
Which monitoring wizard can be used to discover Nokia checkpoint firewall ?
Re: Firewall Monitoring
Posted: Wed Mar 05, 2014 10:24 am
by tmcdonald
For actual discovery? The Auto-Discover wizard under Configure (link on the left).
If you want to actually monitor it I would suggest using SNMP or the Generic Network Device wizard.
Re: Firewall Monitoring
Posted: Mon Mar 17, 2014 5:47 am
by deepavaidya
Hi,
I have to monitor the 'Nokia IP1287' firewall. Which monitoring wizard can auto-scan its ports ? Need to monitor its ports status as well. There may be lot of ports so cannot add each one of them and link it with OID (if operstatus). The ports should be auto-scanned at the time of discovery.
Re: Firewall Monitoring
Posted: Mon Mar 17, 2014 7:44 am
by deepavaidya
Hi,
I just got this plugin
check_snmp_cpfw.pl from
http://nagios.manubulon.com/snmp_cpfw.html
Please can you confirm if it has to be used with NRPE ?
Re: Firewall Monitoring
Posted: Mon Mar 17, 2014 9:32 am
by tmcdonald
I am going to assume not since the world "NRPE" does not appear anywhere on the help page.
deepavaidya wrote:Which monitoring wizard can auto-scan its ports ? Need to monitor its ports status as well. There may be lot of ports so cannot add each one of them and link it with OID (if operstatus). The ports should be auto-scanned at the time of discovery.
Have you looked into the SNMP Walk wizard? It will run the snmpwalk command against the host and compile a list of proper SNMP configs for the ports.