Page 1 of 1
PDF Reports
Posted: Tue Apr 29, 2014 11:37 pm
by Fred Kroeger
Is it possible to get a few of the PDF reports tweaked?
The Exec Summary & Availibility report would be better if the the two pie charts were resized so that they appeared next to each other instead of vertically.
The Alert Histogram has a blank first page and the chart is on the second page.
Thanks - Fred Kroeger
Re: PDF Reports
Posted: Wed Apr 30, 2014 9:21 am
by tmcdonald
I can open up a feature request for this. Can you PM me an example PDF for reference? I haven't seen the blank page issue on my reports.
Re: PDF Reports
Posted: Tue May 06, 2014 5:26 pm
by Fred Kroeger
Thanks - PDF files have been sent.
Regards... Fred
Re: PDF Reports
Posted: Wed May 07, 2014 10:16 am
by lmiltchev
Thanks, Fred! I will follow up with tmcdonald on the feature request and provide you with a task ID for a reference.
Re: PDF Reports
Posted: Wed May 07, 2014 3:10 pm
by tmcdonald
I still have not been able to reproduce the second issue on my end.
What XI version are you running?
Are these the scheduled reports or on-demand?
Are you restricting these to a certain host or service group?
Re: PDF Reports
Posted: Sun May 11, 2014 10:15 pm
by Fred Kroeger
NagiosXI 2012R2.9
Scheduled Reports emailed as a PDF
No restrictions on Host/Service Groups.
I do have a customised logo that is a bit longer than your existing Nagios logo - it is 220 x 45 pixels
However that shouldn't affect why we get a blank page or why the two pie charts aren't side by side.
I have noticed that the Page Title always assumes that the standard ASG logo is used and spaces the title accordingly.
At another site I use an even longer customised logo and have found that the page title ends up superimposed over the logo.
I have always tried to keep the Nagios logo in the logo which is why the customised version is so long.
Oh... also here in Asutralia we use A4 as the page size and not LTR if that makes a difference?
regards... Fred.
Re: PDF Reports
Posted: Mon May 12, 2014 9:38 am
by slansing
Actually, that could, I'd think it would dynamically account for that though. Have you tried switching it back and forth to test?