Page 1 of 1
Check HP MSA P2000
Posted: Sun Jul 06, 2014 11:57 pm
by lannister
Hi ,
Wanted help using the plugin for HP P2000 SAN, regarding commands and services .
Or any other configurations that Im suppose to do.
Thanks
Lan
Re: Check HP MSA P2000
Posted: Thu Jul 10, 2014 1:00 pm
by slansing
Without the actual plugin name or a link to it's listing it's a bit hard to help
, please provide this info, I'm also moving this to the general support forums, Nagios Ideas is not for direct support.
Re: Check HP MSA P2000
Posted: Tue Jul 15, 2014 7:45 am
by lannister
Hi ,
Please find the link for the plugin
http://exchange.nagios.org/directory/Pl ... 00/details
The problem is im unable to open a support in general support forums.
- Lan
Re: Check HP MSA P2000
Posted: Tue Jul 15, 2014 9:22 am
by tmcdonald
lannister wrote:The problem is im unable to open a support in general support forums.- Lan
I'm sorry? You are posting in the general forums currently. Did you mean the customer forums? If so you can send an email to
[email protected] and they will grant you access provided you are a current customer.
Re: Check HP MSA P2000
Posted: Tue Jul 15, 2014 5:11 pm
by Box293
Have you read through and tested the examples as per the website you are directed to:
http://www.toms-blog.com/nagios-hp-msa- ... e-monitor/
By default the plugin checks the status of the P2000 SAN and so only the host address username and password.
./check_p2000_api.php -H 192.168.0.1 -U admin -P password
What is it exactly that you are having troubles with?
Re: Check HP MSA P2000
Posted: Mon Jul 21, 2014 1:22 am
by lannister
Hi ,
Thanks for the reply , There are two queries-:
1. Any command I enter the out put it shows is OK
2. How can I get more commands as only a few ie a couple of commands they have mentioned.
Asides to tmcdonald -: Thanks I have mailed them.
Thanks
Lan
Re: Check HP MSA P2000
Posted: Mon Jul 21, 2014 4:31 pm
by sreinhardt
As box asked, what is it exactly that you are having troubles with. Returning OK for everything is a definite possibility if you have not put any warning or critical thresholds, or if your results are well within those thresholds. Can you give some example commands you have run and their output? How about a check that you expect to fail and is passing with OK?
Are you referring to differing commands that might be available via the end devices api? These may or may not be implemented with the plugin, the author or his documentation would probably be the best route to start figuring out where and what you are looking for.